NORDIK 15625026 Guide De L'utilisateur page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.
Choose a proper window location.
Choose a window that allows the cooled air to flow
freely and directly into the room(s) you wish to cool.
Remember, it is difficult to move air around corners.
Also, choose a window that is within 6 feet of an
electrical outlet. (refer to Electrical Requirements/
Receptacle wiring needs) Do not use an
extension cord.
Installing the unit in a sliding window
1. Attach the support brace to the platform as shown.
Use the adjustment bolt and hex flange nut to complete the
assembly. Choose slot and adjustment bolt hole
locations that will create a 45-degree angle between
the platform and the support brace. Try the assembly in the
window to determine if the platform will rest properly and
allow a proper slope (3/16" lower on the outside).
NOTE:
If you are planning to use a siding-
protection board (refer to Step 5) on the outside of your
house, hold the board in place when testing the assembly
in the window.
2. Measure and lightly mark a line 8-11/16"
from the window jamb.
NOTE:
If any sash stop protrudes more than 1"
from the side window jambs, the 8-11/16"
measurement must be increased accordingly.
Screen and storm window frames may also require
adjustments to the measurement.
3. Center the platform assembly on the line with the
inside platform tab pressed against the inside edge of
the window track. Using the holes in the platform as a
guide, mark and drill two 9/64" diameter holes. Drill
holes in either track or stool.
CAUTION
Property damage hazard-Failure to adhere to
the following precautions could result in
damage to the window or air conditioner.
Be sure the wood stool or window track is securely
attached to the building construction. Use longer
screws in the sub-framing if necessary.
(continued)
Installation Instructions
8
6-foot
power cord
reach
/ " (6 mm) HEX FLANGE NUT
1
4
8 / "
11
16
Center the platform
assembly on the
line with the platform
tab pressed against the
window track
Platform assembly
Alternate screw location
(depending on the stool depth)
Platform tab
Window track
Window seal

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Gjc08ci-a3nrna5a

Table des Matières