NORDIK 15625026 Guide De L'utilisateur page 14

Installing the unit in a casement
window
NOTE:
Open the window to the maximum amount to
allow for clearance of the cabinet. The crank handle
should be removed to allow the platform to be
fastened to the jamb. If the window cannot open far
enough (more than 15-1/2") for the cabinet to
clear the window, remove the window entirely by
drilling out the rivets. Bolts can serve as the pivots in
the future.
To avoid crank handle and window clearance
problems, the unit can be installed in a stationary
sash section. However, the horizontal mullion and the
two-glass panels must be removed before installation.
1. Attach the support brace to the platform as shown.
Use the adjustment bolt and hex flange nut to complete
the assembly. Choose the slot and adjustment bolt
hole locations that will create a 45-degree angle
between the platform and the support brace. Try the
assembly in the window to determine if the platform
will rest properly and allow the proper slope (3/16"
lower on the outside).
NOTE:
If you are planning to use a siding-
protection board (refer to Step 6) on the outside of your
house, hold the board in place when testing the
assembly in the window.
2. Drill a 9/64" diameter pilot hole in the window
jamb at an equal distance from each side of the
jamb and 3/16" up from the window sill. If the
hole coincides with the window lever slot in the jamb
bottom, an additional hole will need to be drilled
through the platform edge and window jamb to
miss this slot.
3. Peel off the protective backing from the track
seal, and stick the seal to the window sill on the
outside of the bottom jamb.
4. Screw the platform assembly to the window
jamb through the pilot hole you drilled in Step 2. Use
a #8x3/4" self-threading screw. (continued)
Installation Instructions
12
/ " (6 mm) HEX FLANGE NUT
1
4
Equal distance from both sides
8 / "
11
16
Apply the track seal to the outside
edge of the bottom window jamb.
Track seal
Screw
Window
jamb
Platform assembly