Controls - NORDIK 15625026 Guide De L'utilisateur

Lights next to the touch pads on the AC control panel indicate the selected settings.
ON/OFF button
Press this button to turn on or turn off
the AC.
Display
1. Under the ON status without the timer
setting, he operation modes are Auto,
Cool, Energy Saving, Fan, or Dry, and
the set temperature will be displayed.
2. Time will be displayed under the timer set-
ting or timer preview status.
Temp Increase
Press this button to set the temperature under
Cool, Energy saving , or Dry mode.
Timer Increase
Each press of the Increase
button on the unit will set the delay time
when using the Timer button on the unit
The Set light will flash while setting.
Fan Speed button
Press this button to set
High, or Auto Fan speed.
Note: Under Dry mode, the fan speed cannot
be adjusted.

Controls

AC controls
/Decrease buttons
/Decrease buttons
/Decrease
Low, Medium,
Mode button
Press this button to set the
Fan, Dry, or Auto mode.
The matching indicator light will turn on. Please note that
under Auto mode, no indicator light will turn on.
Timer button
The setting range is 0.5~24 hr.
Timer ON can be set with the AC OFF. When the timer
reaches ON time, the system will run under the previous set-
ting mode.
Timer OFF can be set with the AC ON. When the timer
reaches OFF time, the unit will turn off. The timer can be
set in 0.5-hour increments below 10 hours and in 1-hour
increments for 10 hours or above.
8
Filter Check button
After 250 hours of operation, the air filter must be cleaned;
the "Clean Filter" indicator light will turn on.
Note: Once the filter has been cleaned, press the Filter
Check button to clear the warning. The "Clean Filter"
indicator light will turn off.
Sleep button
Press this button to go into SLEEP mode.
Press it again to cancel the function. This function is
available in Cool, Energy Saving, or Dry mode to
maintain the most comfortable temperature for you.
15
Cool, Energy Saving,