NORDIK 15625026 Guide De L'utilisateur page 12

10. Clamp the plastic window panel between a board
and a work table, and cut along the cutting line with a fine-
toothed saw. Remove any burrs with a file.
11. Fasten the side channels to the sides of the AC
using three screws (Item 17) per channel. Start with the first
screw at the top of the channel. Make sure channel hook ends
face towards the back of the unit.
12. Slide the plastic window panel into the panel frame,
with the smooth side towards the room. Slide the panel frame
assembly into the side channels of the AC cabinet. Make
sure the plastic window panel is firmly enclosed on all
sides by the retainer grooves.
13. Cut the side channel seal into two equal lengths.
Remove the protective backing and apply it to the rear
side of the cabinet side channels, starting just below the
panel frame assembly. Pinch off the excess length so the
seal is even with the bottom of the cabinet side
channel.
14. To remove the front panel
1. Remove the two front retaining screws from the
front frame.
2. Press firmly on each side of the metal case close
to the front, approximately 2/3 of the way down.
3. While pressing on the sides of the metal case,
gently pull the front out and lift up to release it
from the case.
4. Then remove the four screws from the front frame
to release the control panel box.
NOTE:
DO NOT push or pull the air direction louvers.
15. Place the AC in the window opening. As shown on the
right, it should sit on the platform assembly so that the window
panel frame and cabinet side channels are against the top
and side window jambs. (continued)
Installation Instructions
10
Fastening side channels
Plastic window panel
Apply the weather
seal to the side
channels just
below the edge of the
panel frame.
Screw
retaining
screw
Slide the inner
window sash
firmly against
the cabinet.
Panel frame