FITFIU FITNESS GYM-100 Manuel D'instructions page 48

STEP 4
1. Insert the 50*50(#49) plugs into part(#13). Attach
part (#13) to part (#15) using (1) M10*70(#68) hex
screw. Insert the pin (#54) through the first hole of
part (#15) and through part (#13) to lock part (#13).
Next hole to release part (#13). Note: Tighten the bolt
(#67) and loosen the nut enough for part (#13) to
rotate freely.
STEP 5
1. Attach part (#28) to part (#15) using (2) M8*65
hex bolts (#73).
2. Insert the Ø25(#50) round plugs into part(#25).
Insert part(#25) through part(#15,#13), and
then slide the foam rollers(#52) over them.
94
STEP 6
1. a. Attach part (#27) to part (#5) using (2) M8*65 hex
bolts (#73).
STEP 7
1. Insert the 50*25(#46) plugs and 50*50(#49) plugs into part (#7). Use a mallet to insert the shaft (#26) through
part (#7) and through part (#1) until it is flush with both ends. Attach the shaft (#26) to part (#7) using (2) M8*20 hex
screws (#71). You can rotate the part(#18), and then screw the plastic nut(#40) to lock the part(#7).
2. Put the "L" stops(#45) on the part(#7).
3. Insert the 38*38 plug (#47) into part (#10). Place the cap with hole (#42) into part (#10).
4. Attach part (#10) to part (#7) using (1) Nylon lock nut M16(#59) and (1) Washer Ø16(#62). When tightening the nut,
make sure that part(#10) can rotate. Place the nut cap(#23) on the nut.
5. Slide the Ø80*245(#53) foam onto the part(#10). Hint: water or soap makes it easier.
6. Place the Comfort Grip(#41) on the part(#9,#10).
7. Attach part(#9) to part(#10) using (1)hex screw M10*25(#66).
8. Assemble the other Pec arm (#11) using the same method.
GYM-100
95
EN