Publicité
Les langues disponibles
Les langues disponibles
NOTE: The washer should be placed on both ends of all bolts (against the bolt head and against
the nut) unless otherwise specified in these instructions.
Hand tighten all bolts on initial assembly and finally tighten with the spanner once the entire
structure is erected.
Some parts may come pre-assembled from the factory.
STEP 1
1.
Place the foot caps(#51) on the ends of the parts(#14,#22). Insert the plug 50*50(#49) into the part(#12).
2.
Attach part(#3) to part(#14) using the hexagonal screw M10*25(#63). Tighten the screw with a spanner.
Attach part(#14,#24) to part(#2) using (2)hex bolts M10*75(#67). Tighten the bolt with a spanner here.
3.
Attach part (#12, #22) to part (#2) using (2) M10*75(#67) hex bolts.
4.
Attach part (#6) to part (#2) using (2) M10*75(#67) hex bolts.
92
STEP 2
1.
Slide the Ø62*16 weight buffer (#39) and the weight stack through the guide rods (#3) in succession.
NOTE: Carefully slide the Weight Plates (#33) one by one onto the guide rods, do not lift
more than you can safely control.
2.
Place the weight bushing(#35) on the weight selector bar(#37) and fix it in the first hole of the weight
selector bar(#37) using the weight pin(#36). Insert the Bar(#37) into the hole of the Weight Plates(#33).
Slide the upper weight plate(#32) into the weight stack. Place the weight washer(#34) into the hole in
the upper weight plate(#32). Insert the "L" pin(#38) through the bar(#37) to obtain the proper weight.
3.
Attach part (#15,#23) to part (#6) using (2) M10*75(#67) hex bolts.
STEP 3
1.
Insert the 50*50(#49) plugs into part(#1).
2.
Attach part(#1) to part(#5) using (2)
M10*75(#67) hex bolts.
3.
Insert each of the guide rods (#4) into the
holes in part (#1), and then attach part (#1)
to the guide rods (#4) using (2) M10*25 hex
bolts (#66).
4.
Insert the plug 38*38(#47) into the part
(#8). Place the cap(#48) on part(#8). Attach
part(#8) to part(#5) using (2)Hex bolts
M10*70(#68).
5.
Attach part(#18) to part(#8) using (1)Hex
bolt M8*45(#72). Screw the plastic nut
(#40) to part (#18).
6.
Attach part(#21) to part(#5) using (2)
M10*65(#69) hex bolts.
GYM-100
93
EN
Publicité
