Dörr DLP-100W Notice D'utilisation page 16

04.3 Removing/attaching the diffuser panel
To remove the diffuser panel, press the release button (03) down and slide the panel out of the guide rails to the right.
To refit the diffuser panel, make sure that the panel is inserted in the upper and lower guide rails. Slide the panel to the left until the
release button (03) sticks out completely again. You may have to lift the panel slightly on the left-hand side to be able to push the
panel in as far as it will go.
04.4 Operation with power adapter
Make sure that the main switch (17) is in position "0" (= off). Insert the connector (19a) into the socket (18) at the LED light. Pay
attention to the pins and holes. Screw tight the screw lock (19b).
IMPORTANT: To disconnect the cable connection, make sure to open the screw lock (19b) first!
Connect the power supply (19) to a socket with a mains voltage of 100-240V.
ATTENTION: Do not use an extension cable. Make sure that no one can trip over the cable connections.
04.5 Operation with V-Mount Li-Ion battery (optional)
ATTENTION: Operate the continuous light only with a special V-Mount Li-Ion battery suitable for the continuous light
(optionally available). When inserting the battery, pay attention to the correct polarity (+/-). When not in
use for a longer period of time, please remove the battery.
Make sure that the main switch (17) is in position "0" (= off). Push the battery into the V-shaped battery connector (10) from the
right until the battery audibly clicks into place. To remove the battery again, make sure that the main switch (17) is in position "0"
(= off). Press the unlock button (11). Slide the battery out of the connector to the right.
V-Mount Li-Ion batteries optionally available from DÖRR:
DÖRR Compact V-Mount Li-Ion Battery CVL-98 14.8V, 98Wh
Switch the continuous light on the main switch (17) to position I (=On).
16 doerr-foto.de