Publicité
Les langues disponibles
Les langues disponibles
04 | OPERATION
Note:
Before using for the first time, carefully remove the protective film from the LED diffuser panel and from the display.
04.1 Mounting the swivelling bracket
To mount the continuous light on the swivelling bracket (05) screw the two locking screws (04) each with the black rubber ring (04a)
and the silver washer (04b) like shown in the following sketch:
04.2 Mounting on light stand
Mount the continuous light on a light stand (optionally available from DÖRR) as described below.
Only with SET article no. 373513:
Pull the tripod legs down until the centre struts (20d) are approximately horizontal. Tighten the locking screw (20c).
Slightly loosen the locking screws (20b) to adjust the lamp stand with the 3 extensions to the desired height. Tighten the locking
screws (20b) again.
Screw the locking screw (06) all the way in and place the light stand holder (07) on the threaded spigot (20a).
ATTENTION:
To avoid tilting of the LED light, align the light surface of the continuous light over a wide tripod leg.
Tighten the locking screws (06) again.
Loosen the side locking screws (04) on the swivelling bracket (05) to align the continuous light. Tighten the locking screws (04) again.
ATTENTION:
To align the continuous light during operation, touch the continuous light only on the two handles (08).
15
doerr-foto.de
Publicité
