Connecting The Ac Adapter - Omron HBP-1320 Mode D'emploi

HBP-1320-E main.book Page 15 Tuesday, May 8, 2018 5:16 PM
Battery charging
State
Charging
Fully charged
(Charging completed)
Problem with the
battery
Battery level
Battery level
Fully charged
Battery level is 20%.
Battery level is 5%.

Connecting the AC Adapter

AC power
Verify that the power outlet supplies the specified voltage and frequency (100 - 240 V AC, 50/60 Hz).
Connect the AC adapter to the DC jack on the unit and the power outlet.
To disconnect the power outlet, unplug the AC adapter from the power
outlet first and then remove the AC adapter plug from the unit.
Note:
When the battery pack is installed
If there is no problem with the following.
- AC adapter
- DC jack
- Power outlet
- Battery
And the icon does not flash, contact your OMRON retail dealer or distributor.
LCD contents and operations
The icon flashes.
The icon is lit.
Error message is displayed.
LCD contents and operations
The icon is lit.
The unit can be used.
The icon flashes (E40 error not displayed).
The unit can be used.
The icon flashes (E40 error displayed).
The unit cannot be used.
If the unit is being continuously used, the power will be
automatically turned off in 30 seconds.
Icon
-
Icon
-
EN
15