Correcting Data On A Program That Is Running; Changing The Program In Progress; Checks During Work - Zhermack furnace DM Serie Manuel De L'utilisateur

CORRECTING DATA ON A PROGRAM THAT IS RUNNING

7.11
If for some reason the operator decides to change the data once the program has already been
launched, he/she must proceed as follows:
A. Press START-STOP (20): the word OFF appears on the display (11).
B. Press PROG. (19): the legend "Pro" appears on the display (11).
C. Press ENTER and the following occurs on the control panel:
• the green horizontal segment of the recalled phase comes on.
• the first of the three parameters (i.e. temperature) (11) appears.
• the number of the recalled phase appears on the display (15).
• the green PROG. LED (27) flashes.
D. Change/cancel one or more of the phase data items.
E. Save all changes by pressing ENTER.
F. Press START/STOP (20) to return to the display (11): F appears.
Key in the number of the phase from which you wish to begin.
G. Press START/STOP (20).

CHANGING THE PROGRAM IN PROGRESS

7.12
If an undesired program is launched by mistake, proceed as follows:
A. Press START-STOP (20): OFF reappears on the display (11).
B. Press SELECT./PROG. (12): "P" appears on the display (14).
C.
Press the correct program key: the corresponding number appears on the display (14).
D. Set the oven start time as described in Chapter 4 "Programming Oven Start Time".

CHECKS DURING WORK

7.13
Several checks can be run while the oven is working:
A. During phase 1 / Delayed start on
1. Pressing TEMP. (17) on the display (11) causes the current in-chamber temperature to appear.
• after a few seconds the display returns to its previous state.
168 of 272
MAINTENANCE AND USE MANUAL
EN
FURNACE DM