Delayed Start; Correcting Data - Zhermack FURNACE DE 1 Manuel D'utilisation Et D'entretien

MAINTENANCE AND USE MANUAL
For a delayed or programmed oven start proceed as follows:
A. Go through all the data programming procedures described in paragraph 7.3.
The oven is OFF as indicated on the display (1).
Press the CYCLE key (5) on the control panel and the following happens:
• the PROG. LED (4) flashes and will continue to flash as long as the operator remains in
the programmed or delayed start stage;
• four zeroes appear on the display (1) to set the hours and minute; act on the "-" (7) or
"+" (8) keys.
The two figures on the left-hand side of the display (1) indicate the hours while the
two figures on the right-hand side indicate the minutes.
For example, to enter "08.30": enter "0", enter "8", press the PROG. key (5), enter "3"
and finally enter "0".
B. Press CYCLE (6)
The following appears on the control panel:
• the green CYCLE LED (3) comes on.
• the hours and minutes appear entered for the delayed kiln start appear on the display (1).
• the middle of the display flashes to indicate that the time the countdown is running.
C. At the pre-set oven start time a beeper warns the operator that the delay is over and the
oven heating stage has begun.
To vary the settings repeat the above procedures after first pressing the CYCLE
key (5) to exit programming and bring the oven back to its initial OFF mode.
The operator can change or correct settings at any time during programming, the delayed start
countdown or even when the oven is working:
• Press the CYCLE (5) key.
The word OFF appears on the display (1).
Re-programme as per the desired work cycle.
FURNACE DE 1 / DE 2 / DE 3
EN

Delayed start

CORRECTING DATA

137 of 260
7.3.2
7.4