Creating An 8-Phase Work Cycle; Choosing A Program - Zhermack furnace DM Serie Manuel De L'utilisateur

MAINTENANCE AND USE MANUAL
DM series ovens provide users with cycles having up to 8 work phases. This is made possible by uniting
programs 8 and 9. Proceed as follows:
A. With the oven OFF press key 9.
• the display (11) shows: "8 9 normal functions" or "8 9 combined 8-phase mode".
If the display (11) shows 8 9, press the PROG key or key 9 again.
• 8 – 9. appears on the display (11).
• press ENTER to save.
B. Now set program 8.
After setting the holding time in phase 5 of program 8 the oven automatically goes to phase
2 of program 9.
C.
Now set the data for program 9.
D. After setting the fan shutdown temperature and confirming the data by pressing ENTER,
the duration of the combined program appears on the display (11).
E. Press ENTER again:
• OFF appears on display (11)
• 9 appears on display (14)
• 1 appears on display (15).
F. Now recall program 8 by proceeding as follows:
• press the PROG. SELECT. key (12).
• "P" appears on display (14).
• press key "8" on the numerical keypad.
If you wish to return program 8 to its standard 4-phase operating mode, proceed as follows:
• with the oven OFF, press key 9.
• 8 - 9 appears on the display (11).
• press key 9 again or press PROG.
• 8 9 appears on the display (11).
• press ENTER.
To recall the desired program proceed as follows:
A. With the oven OFF press PROG. SELECT (12). The letter "P" appears on the display (14).
B.
Press the number (0 - 9) relevant to the program you wish to enter.
FURNACE DM
EN

CREATING AN 8-PHASE WORK CYCLE

CHOOSING A PROGRAM

7.7
7.8
165 of 272