Zhermack furnace DM Serie Manuel De L'utilisateur page 143

MAINTENANCE AND USE MANUAL
• Do not open compartments containing electrical parts.
• Have the equipment inspected by the Manufacturer and/or Authorised Dealer at least one every 12
months.
• Do not replace the power lead or tamper with the supplied plug.
• It is forbidden to use the equipment on items other than those for which it has been specifically
designed.
• Before doing any cleaning, routine and/or unscheduled maintenance work make sure that the
equipment has been unplugged from the mains socket.
• Make sure that there are no foreign objects inside the work area as these could damage the
equipment and/or injure personnel.
• Do not use petrol or flammable solvents as detergents; use only non-flammable, non- corrosive, and
non-toxic substances (see paragraph 8 .1).
• Do not used compressed air to clean small pieces; if you do so you should protect your eyes with
goggles that provide lateral protection and limit air pressure to a maximum of 2 bar.
Zhermack cannot be held liable for any damage to persons or objects caused by
incorrect maintenance carried out by unqualified personnel or maintenance work
that does not comply with the instructions in this manual.
Zhermack is, as of this moment, exonerated from any liability concerning injury to
persons or damage to objects that may result from using this equipment in a way
other than that described in this manual.
This equipment has electrical parts: therefore, in the event of a fire, no matter how
small, use only powder-type extinguishers. Never attempt to put out an
electrical fire with water.
FURNACE DM
EN
143 of 272