Description Of Control Panel Components - Zhermack furnace DM Serie Manuel De L'utilisateur

MAINTENANCE AND USE MANUAL
Control panel structure/functions are the same on all DM ovens.
To aid comprehension during the programming phase too the display panel table is shown both on
the facing page and in the fold-out Appendix A.5 at the end of this Use and Maintenance Manual.
1.
Phase 1
2.
Phase 2
2a.
Phase 2
3. Phase 3
3a. Phase 3
4.
Phase 4
4a.
Phase 4
5.
Phase 5
5a.
Phase 5
6.
Wait LED
7. Work LED
8. °C
9.
°C/MIN
10.
HR-MIN
11.
Data display
12.
PROG. SELECT.
13.
PHASE
14. Selected program n° display
15. Phase n° display
16.
Main switch
17.
TEMP.
18.
TEST
19.
PROG.
20.
START/STOP
21. ERASE
22. LED TIME
23.
LED SLEW RATE
24.
LED STO TEMP
25.
LED TEMP
26.
LED --------
27.
LED PROG.
28. ENTER
FURNACE DM
EN

Description of control panel components

Horizontal segment – Delayed start phase
Shows temperature setting on display
Shows temperature increase rate setting on display
(on DM1-DM1G there is an on/off light)
Programming and time (hours and minutes) reading
Programming and fast reading of rate in °C per minute
Programming and temperature stop reading (in °C)
In-chamber temperature on display (in °C)
Oblique segment - Increase phase
Horizontal segment - Holding phase
Oblique segment - Increase phase
Horizontal segment - Holding phase
Oblique segment - Increase phase
Horizontal segment - Holding phase
Oblique segment -Increase phase
Horizontal segment -Holding phase
Wait/delayed start on
Work/oven running
Shows remaining holding time
Selects programmes 0-9
Selects phases 1 - 5
Shows in-chamber temperature
Checks the board functions
Access to programmes
Start/stop work
Cancels data on display (11)
Programming LED
Saves (confirms) on-display data (11)
3.5.1
Element on
147 of 272