SELFSAT SNIPE PLATINUM Manuel Utilisateur page 23

G. PI box and Remote control installation
G-1
Get Power input cable and plug into cigar
lighter socket (12V outlet)
G-3
12V DC
Match the power cables polarities to the
battery polarities, red to red / black to black and
white ignition cable to ignition port of the
vehicle
G-5
Connect power-PI box-receiver using cigarette
lighter adaptor and PI cable
Ignition
ENGLISH - 22
G-2
To source power from car battery, cut off
cigar-jack connector to take inner three cables
out and peel off each to take copper cable out
G-4
STB
approx.1.5m
Fix PI Box where it should be fixed using two(2)
of M4x20 screw
G-6
Fix Remote control bracket where it should be
fixed using two(2) of M4x20 screw