SELFSAT SNIPE PLATINUM Manuel Utilisateur page 12

F. Error message
W - E9 : FC D
ASTRA 1
Error ELdn
G. Additional function
SELECT MAC
WM - E9 : FC : E4
PRESS SET
3. Mobile application
A. Download the app from the App Store (Android/iOS)
Search for SELFSAT on the App Store and download "SAT CONNECT" app
※ Before using this app, need to activate BT and GPS function on your smart device.
B. Pairing the antenna with App
step 1. Check the MAC Address at your antenna unit (on the antenna or PI box / User manual)
step 2. When you run the downloaded application, a connectable antenna unit is automatically detected
step 3. Select the one that matches your antenna MAC Address
There are two antenna MAC addresses, one starting with WM- and one starting with WP.
For satellite search operation, must select a MAC address that starting with WP.
step 4. Click the 'connect' button to complete Bluetooth connection between your antenna unit and
smart device
If an error occurs during operation, the error code appears with the error statement.
Error ELdn - EL Movement
Error COM - Communication error
If an error message appears, turn off the power of the STB and PI, disconnect all
connected cables, and reconnect them
MAC addresses starting with WM are used for special operations, When pairing to
the product using this MAC address, other functions cannot be used (such as
satellite search).
Do not select in normal operations, other than emergency mode or firmware
update mode
※ Emergency mode
If the antenna is stopped in an abnormal state with 'ERROR Com' displayed on the
remote control (or the PI was brokendown), the antenna can be returned to its
home position through the following process
1. Instead of PI, connect another 24V power supply directly to the antenna. (Via
coaxial cable)
2. Pair by selecting a MAC address starting with WM- instead of a MAC address
starting with WP with the app or remote control
3. When you press the home button on the remote control, the antenna returns to
the home position
ENGLISH - 11