Kaiser HGE 93 Serie Mode D'emploi page 8

Masquer les pouces Voir aussi pour HGE 93 Serie:
Table des Matières

Publicité

TECHNISCHE SICHERHEIT
Das Gerät darf nur von einer qualifizierten
Fachperson eingebaut und angeschlossen
werden.
Kontrollieren Sie das Gerät auf sichtbare
Schäden. Beschädigungen der Technik
können Ihre Sicherheit gefährden. Nehmen
Sie niemals ein beschädigtes Gerät in
Betrieb.
Reparaturen
qualifizierten
werden. Bei einer nicht fachgerechten
Reparatur bringen Sie sich oder andere in
Gefahr. Wenn Ihr Gerät eine Reparatur
benötigt, wenden Sie sich bitte an unseren
Service.
Wenn das Netzkabel defekt ist, muss es
durch
einen
werden.
Elektrische Leitungen dürfen das Gerät
nicht berühren.
Das Gerät soll mit Hilfe eines zugelassenen
Schutzschalters oder Sicherung an die
Stromversorgung angeschlossen werden.
Verwenden
Steckdosenadapter oder Verlängerungs-
kabel um das Gerät an das Stromnetz
anzuschließen.
Die Stromversorgung des Gerätes soll vor
der
Reparatur
ausgeschaltet werden.
Dieses Gerät darf nicht an nichtstationären
Aufstellungsorten (z. B. Schiffen) installiert
werden.
Achtung!
Vor dem Auswechseln der Lampe
schalten Sie das Gerät ab, um einen
möglichen elektrischen Schlag zu
8
DE
dürfen
nur
von
Fachperson
durchgeführt
Servicefachmann
ersetzt
Sie
niemals
mehrere
oder
Reinigung
vermeiden.
TECHNICAL SAFETY
Installation of this appliance must be
performed only by a licensed specialist The
installer is responsible for connecting the
appliance to the mains power supply in
observance
recommendations.
Check the appliance for visible signs of
damage before using it. If the appliance has
been damaged in transport, do not connect
it. Never use a damaged appliance! It could
be dangerous!
einer
Repairs should be performed by a licensed
technician only. Improper repair may result
in considerable danger to you and others. If
your appliance needs repair, contact a
Service Centre or your dealer.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
Electrical leads and cables must not be
touching the appliance.
The appliance should be connected to the
mains power supply by means of an
approved circuit breaker or fuse. Never use
multiple plug adapters or extension leads to
connect appliance to the mains electricity
supply.
The power supply of the appliance should
be turned off before repair or clean.
This appliance must not be used in a non-
stationary location (for example on a ship).
Attention!
shock, the appliance should be powered down
before replacing the
EN
of
the
relevant
To avoid the possibility of electric
lamp.
safety

Publicité

Table des Matières
loading

Produits Connexes pour Kaiser HGE 93 Serie

Table des Matières