I Image Adjustment - Panasonic WV-CF324 Mode D'emploi

Cable type
RG-59/U (3C-2V) Approx. 250 m {825 ft}
RG-6/U (5C-2V) Approx. 500 m {1 650 ft}
RG-11/U (7C-2V) Approx. 600 m {1 980 ft}
RG-15/U (10C-
Approx. 800 m {2 640 ft}
2V)
G Power connection
Connect the three-conductor cable of the
camera to the power supply. The wire colors
and functions are shown in the table.
Wire color 12 V DC
Brown Positive
Blue Negative
Green/yellow Grounding
Caution: Be sure to connect the GND
(grounding) lead of the camera and
grounding terminal of the power supply
when using a 24 V AC power source.
G Cable Length and Wire Gauge
24 V AC
The recommended cable length and thick-
ness are shown in the table for reference.
The voltage supplied to the power terminals
of the camera should be within 19.5 V AC
and 28 V AC.
Recommended wire gauge for 24 V AC line.
Copper wire
#24
2
(0.22 mm ) (0.33 mm
size (AWG)
(m) 20
Length of
Cable
(Approx.)
(ft) 66
Extensible length
24 V AC
Live
Neutral
Grounding
#22 #20 #18
2 2
) (0.52 mm ) (0.83 mm
30 45 75
100 150 250
12 V DC
Use the formula below to calculate the power
cable and power supply. The voltage sup-
plied to the power terminals of the camera
should be within 10.8 V DC and 16 V DC.
Resistance of copper wire [at 20 °C {68 °F}]
Copper wire
(0.22 mm
size (AWG)
Resistance
0.078
Ω/m
Resistance
0.024
Ω/ft
10.8 V DC ≤ V
L: Cable length (m)
R: Resistance of copper wire (Ω/m)
V : DC output voltage of power supply
A
unit
I: DC current consumption (A)
See specifications.

I Image Adjustment

1. Connect an adjusting monitor to the
monitor output jack.
2. Pan, tilt and azimuth adjustment
Important:
• Adjust the camera after removing the
shipping lock screw (blue screw).
• Do not touch the iris motor. Failure to
observe this may cause trouble.
• Do not hold the camera by the lens unit
when adjusting
azimuth.
At the same time for the pan and tilt adjust-
ments, make zoom and focus adjustments of
Step 3.
q Rotate the panning table to adjust the
panning position of the camera. (Range:
320 °)
• The adjusting range is from +180 °
(clockwise) to –140 ° (counterclockwise).
2
)
• Tighten the panning table lock screw
after adjusting.
#24 #22 #20
2 2
) (0.33 mm ) (0.52 mm
0.050 0.03
0.015 0.009
- 2 (R x I x L) ≤ 16 V DC
A
panning,
#18
2 2
) (0.83 mm )
0.018
0.005
tilting, or
13