Installations And Connections; I Preparations - Panasonic WV-CF324 Mode D'emploi

Installations and Connections

Caution:
ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.
The following installation should be made by qualified service personnel or system installers.

I Preparations

Important:
• Procure 4 mounting screws according to the material of the installation area. In this case,
wood screws and nails should not be used.
Recommended tightening torque is as follows.
M4: 1.6 N·m {1.18 lbf·ft}
• Required pull-out capacity of
a single screw/bolt is 196 N
{44.1 lbf} or more.
• If a ceiling board such as
plaster board is too weak to
support the total weight, the
area shall be sufficiently rein-
forced.
• The protection sheet attached
to the dome cover shall be
peeled off after installation.
G Direct mounting
If the camera is directly mounted on a
wall/ceiling, align the camera mounting posi-
tion with the position of the hole through
which the cables run and make the hole.
If no hole is made through a wall/ceiling and
open wiring along a wall/ceiling is used,
process the cover so that the cables can be
run through the side of the cover.
Processed section of the side
surface of the cover
46 mm {1.81"}
4.5 mm
{0.18"}
<Back/upper>
G Using a two-gang junction box
When using a two-gang junction box (4" x
4"), procure one locally that meets the
dimensions in the figure.
And then, locally procure four camera-
mounting screws suitable for the installation
surface and structure of the wall/ceiling or
two-gang junction box.
Side cable access hole
Camera fixing hole
ø4 - 4.5 mm {0.16" - 0.18"}
Cable access hole
for wall/ceiling
ø30 - 50 mm {1.18" - 1.97"}
11