De-Commissioning And Demolition - La Marzocco linea Serie Manuel De Fonctionnement

not provided
not provided
WATER FILTER
(not provided)
MOTOR
PuMP
Fig. 3 (see also pag. 7)
Start by setting the main switch (part 1) to
the "0" position.
Disconnecting from the power outlet
In case the machine is connected through
the plug (part 24), make sure that the
switch (part 23) is also in the Off posi-
tion before disconnecting. Disconnect the
motor pump (part 15) by pulling out its
special plug (part 25).
Disconnecting from the water system
Shut off the water supply by closing the
specific tap located upstream of the puri-
fier inlet. Disconnect the water pipe at the
purifier (part 17) inlet, which is located
just downstream of the special tap (part
18), which has been closed in advance.
Proceed to remove the drain well piping
(part 19).
At this point, the machine may be
removed from the bar, being very careful
not to drop it.
The machine is made out of various mate-
rials and therefore, if you do not intend to
put it back in service, it must be taken to a
special disposal company which will select
the materials which can be recycled and
discard the others.

8. De-commissioning and demolition

Current regulations make it illegal to dis-
card such machine by leaving it on public
grounds or on any private property.
Recycling notice:
Warning for the protection of the
environment.
Old electrical equipment is made of
valuable materials, it is not normal
domestic waste! We kindly ask that our
clients to contribute to the protection of
the environment and natural resources by
delivering this equipment to the relevant
recycling centers, if they such centers are
available in their country.
20