Toro 51466 Manuel De L'utilisateur page 4

4. Install the guard as shown, snapping it into both
sides of the trimmer.
Caution
The blade under the guard is sharp and can cut
you. Be careful when handling the trimmer so
that you do not accidentally cut yourself.
5. Install the metal wire
guide.
6. Secure the wire guide with the thumb screw.
7. Connect the
shoulder strap to the
trimmer, if desired.
8. Adjust the strap
length by sliding the
adjustment buckle to fit
you comfortably.
4
Installing the Charger
Mount the charger indoors (such as a garage or other
dry place), near a power outlet, and out of reach of
children. Ensure that the area is free of clutter and
debris. You must also ensure that the charger is high
enough so that the trimmer can hang unobstructed
below it.
Two wood screws are provided for mounting the
charger. If you want to mount the charger on wall
board, purchase two wall anchors for the screws.
1. Place the charger against the wall and mark the
two hole locations.
m–5771
2. Drill pilot holes as follows:
If installing the charger on wall board, plaster,
or cement, drill two holes for the wall anchors
(as indicated by the wall anchor
manufacturer) at the marked locations.
If installing the charger on wood, drill two
m–5783
holes, slightly smaller than the diameter of
the screw threads, at the marked locations.
3. If installing the charger on wall board, plaster, or
cement, insert the two wall anchors into the holes.
4. Hold the charger against the wall and drive the
screws into the wall anchors or holes.
m–5784
m–6307
3327–488
m–5787