Installation; Unpacking; Check Of Identification Data; Switching On And Off - Videotec CBZ220 Manuel D'instructions

Installation

The following procedures must be carried out with power supply off, if not otherwise specified.
The installation must be carried out only by qualified technical staff.

Unpacking

If the packing shows no relevant defects (due to falls or anomalous abrasions), check the material contained,
according to the list given at chapter Introduction, Packing contents (page 2).
The installer technician is required to dispose of the packing material according to the differentiated collecting
modalities or ,anyway, according to the normative laws in force in the Country of use.

Check of identification data

Before installing the appliance, check that the material supplied corresponds to the specifications indicated on
the data plate, following the chapter Identification data (page 3). Do not carry out any modification or connections
which are not provided for in this manual: the use of improper appliances may seriously compromise the safety of the
personnel and the installation.

Switching on and off

Before connecting the appliance:
• Check that the power supply of pan & tilt motor corresponds to the mains voltage specified in the keyboard data
plate
• check that the material supplied corresponds to the specifications indicated on the data plate, following the chapter
Identification data (page 3)
• check that the keyboard and the other components of the installation are closed in order to avoid a direct contact
with energized parts
• the keyboard and the other appliances of the installation must rest on a large and solid base
• the power supply cables do not have to hinder the common operations of the installer technician
• check that the electrical capacity and the extensions eventually used will support the power consumption of the
system.
SWITCHING ON: the keyboard has no switch: connect the power supply cables.
SWITCHING OFF: disconnect the power supply cables.
Page 5 MNVCCBZ_0828