Connection Of The Cbz220/Cbz24 Keyboard To Zoom Lens; Connection Of Cbz24 Power Supply Cables; Configuration Of The Cbz220/Cbz24 Keyboard - Videotec CBZ220 Manuel D'instructions

Connection of the CBZ220/CBZ24 keyboard to zoom lens

Connections of polarity inversion zoom lenses:
Where to operate: output cable for zoom lens connection
Settings: connect the wires to the zoom lens according to the following table:
Connections of common ground zoom lenses:
Where to operate: output cable for zoom lens connection
Settings: connect the wires to the zoom lens according the following table:

Connection of CBZ24 power supply cables

WARNING: before connecting, make sure that the mains corresponds to the voltage indicated in the keyboard
data plate.
Where to operate: output cable for power supply connection
Settings: connect the three wires according to the following table:
For CBZ220, version 230Vac, there is one SHUCO plug.

Configuration of the CBZ220/CBZ24 keyboard

The CBZ220/CBZ24 keyboard is preset for 12Vdc output voltage on zoom lens contacts.
It is possible to take this voltage to 6Vdc:
Where to operate: Jumper placed in the upper part of the circuit inside the keyboard
Settings:
1. Disconnect the appliance
2. Remove the three clamping screws on the right side
3. Set the jumper according to the scheme
4. Close the side by locking the screws
Output wires from CBZ220/CBZ24
BLACK
VIOLET
RED
BLEU
RED/BLEU
GREY/PINK
Output wires from CBZ220/CBZ24
BLACK
RED
RED/BLEU
VIOLET
BLEU
GREY/PINK
Output wires from CBZ24
BLEU
BROWN
YELLOW/GREEN
Connection to the
zoom lens
Zoom
Zoom
Focus
Focus
Diaphragm (IRIS)
Diaphragm (IRIS)
Connection to the zoom
lens
Zoom
Focus
Diaphragm (IRIS)
Common
Common
Common
Connection to power
supply
24Vac
24Vac
6 V= ca
Page 8
12 V= ca
MNVCCBZ_0828