Connectors And Connections; Installation Example; Cables - Videotec CBZ220 Manuel D'instructions

Connectors and connections

The installation must be carried out only by qualified technical staff: an improper connection of the peripheral
units may cause the keyboard to be isolated from the rest of the system.

Installation example

Installation controlled by one operator with one monitor: the operator controls one pan & tilt motor and the
camera functions FOCUS, ZOOM, IRIS:

Cables

Different types of stroke have been used in the previous examples, in order to indicate cables with different
functions:
video cable:
RG 59 coaxial cable or equivalent cable
multipolar cable:
each control function of the positioning device is activated /deactivated by a relay positioned inside the receiver.
Fix the final numbers of wires according to the following directions:
7 wires for the motion of the positioning device: right, left, up, down, autopan, common, ground
6 wires for the control of polarity reversal lenses (zoom, focus, iris)
4 wires for the control of common wire lenses (zoom, focus, iris)
2 wires for the auxiliary device
Note: We recommend the use of different multipolar cables for high tension and low tension functions.
Minimum section area recommended: 0.56 mm.² (AWG 20) for high tension wires (positioning device)
7 wires-cable for the
control of the P&T head
CBZ220/CBZ24
0.34 mm.² (AWG 22) for low tension wires (lens, auxiliary device)
Page 6
MATERIAL USED
Control keyboard:
• CBZ220/CBZ24
1 control keyboard
Video handling:
•
1 monitor
Telemetry handling:
•
1 pan & tilt motor
•
1 motorized zoom lens
MNVCCBZ_0828