Changing The Exhaust Direction; Using The Nose Cap; Maintenance And Inspection - Hitachi N 3804AB3 Manuel D'instructions Et De Sécurité

English

CHANGING THE EXHAUST DIRECTION

WARNING
When changing the exhaust direction,
be sure to remove your finger from the
trigger and disconnect the air hose from
the stapler.
The direction of the exhaust vent can be changed by
turning the top cover.
Exhaust
vent

USING THE NOSE CAP

WARNING
When detaching or attaching the nose
cap, be sure to remove your finger from
the trigger and disconnect the air hose
from the stapler.
NOTE:
The information contained in this Manual is
designed to assist you in the safe maintenance of
the Stapler.
Some illustrations in this Manual may show details
or attachments that differ from those on your own
Stapler.

MAINTENANCE AND INSPECTION

Read section titled "SAFETY" (pages 4 – 6).
WARNING
Disconnect air hose and remove all
staples from Stapler when:
1) doing maintenance and inspection;
and
2) clearing a jam.
16
The nose cap is attached to the push lever tip to protect
the workpiece from scratches or damage. Remove in
the order shown below when not using.
1 DISCONNECT AIR HOSE FROM STAPLER.
2 Pull out the nose cap in the direction of the arrow
Top cover
MAINTENANCE
1.
Lock lever
as shown in the diagram.
Attach to the tip of the push lever in the reverse
order of detaching.
Firing head
Push lever
Nose cap
Clearing a jam
Remove a jammed staple in the following order:
1 DISCONNECT AIR HOSE.
2 Remove all staples.
3 Release the lock lever and open guide plate.
3
3
Guide plate
Disconnect
1
air hose
1
Disconnect
air hose