Publicité
Les langues disponibles
Les langues disponibles
EN GLI SH
2. Remove flat head screws (mm) from storage
holes on parallel fence.
3. Slide parallel fence into parallel fence slot (j) on
side of base. Insert the two flat head screws
through the appropriate holes in the sub base to
secure the parallel fence. Tighten hardware.
4. Follow all instructions included with the parallel
fence.
NOTE: To remove the parallel fence, reverse the
above procedure. After removing parallel fence
always replace the two flat head screws (mm) into
the storage holes on the parallel fence to prevent
loss.
Using a Parallel Fence With Guide
Rods (plunge base only: D26203,
D26204)
A parallel fence with guide rods may be included
with your plunge base unit. A premium parallel fence
(model DE6913) is also available from your local
retailer or service center at extra cost.
FITTING THE PARALLEL FENCE (FIG. 7B)
1. Attach the guide rods (rr) to the router base (ss).
2. Attach the thumb screws (tt) and springs (qq) to
the base.
3. Tighten the thumb screws (tt).
4. Slide the parallel fence (uu) over the rods.
5. Attach thumb screws (tt) and springs (qq) to the
parallel fence.
6. Tighten the thumb screws (v v) temporarily.
Refer to Adjusting the Parallel Fence.
ADJUSTING THE PARALLEL FENCE (FIG. 1, 7C)
Follow the assembly instructions included with the
parallel fence.
1. Draw a cutting line on the material.
2. Lower the router carriage until the cutter is in
contact with the workpiece.
3. Lock the plunge mechanism by releasing the
plunge lock lever (p)
4. Position the router on the cutting line. The outer
cutting edge of the cutter must coincide with
the cutting line.
5. Slide the parallel fence (uu) against the
workpiece and tighten the thumb screws (v v).
44
Vacuum Attachment
(Fixed Base Only, fi g. 8)
WARNING: To reduce the risk of
injury, turn unit off and disconnect it
from power source before installing
and removing accessories, before
adjusting or when making repairs.
An accidental start-up can cause injury.
To connect the router to a vacuum cleaner for dust
collection, follow these steps:
1. Remove the motor unit from the base unit, see
Motor Quick Release.
2. Attach vacuum attachment accessory (v) to
the base as shown. Tighten thumb screws (w)
securely by hand.
3. Attach hose adapter to vacuum attachment
accessory.
4. When using vacuum attachment, be aware of
the placement of the vacuum cleaner. Be sure
that the vacuum cleaner is stable and that its
hose will not interfere with the work.
Vacuum Attachment
(Plunge Base Only, fi g. 9)
1. Remove the motor unit from the plunge base,
see Motor Quick Release.
2. Slide tab (hh, inset) on vacuum attachment into
slot in plunge base and snap tab (ii, inset) into
hole in plunge base.
3. Secure to base with supplied plastic washer (jj)
and thumb screw (kk). Tighten thumb screw
securely by hand.
4 Attach hose adaptor to vacuum attachment.
5. When using vacuum attachment, be aware of
the placement of the vacuum cleaner. Be sure
that the vacuum cleaner is stable and that its
hose will not interfere with the work.
Set-up: Fixed Base
INSERTING THE MOTOR INTO THE FIXED BASE
(FIG. 1, 2)
WARNING: To reduce the risk of
injury, turn unit off and disconnect it
from power source before installing
and removing accessories, before
adjusting or when making repairs.
An accidental start-up can cause injury.
1. Open the locking lever (i) on the base.
2. If the depth adjustment ring (b) is not on the
motor, thread the depth adjustment ring (b)
Publicité
