Regin E-DSP Instructions page 2

E-DSP
IMPORTANT: Read these
!
instructions before installation
and wiring of the product
115
25
Measurements in mm.
Box 116, SE-428 22 Kållered, Sweden
Tel: +46 31 720 02 00, Fax: +46 31 720 02 50
www.regin.se, info@regin.se
INSTRUCTION
External display for Corrigo E and
EXOcompact
E-DSP is an external display intended for Corrigo E and
EXOcompact models without internal display and buttons. E-DSP
is delivered with a permanently connected cable. There are two
models, E-DSP3 and E-DSP10, with cable lengths 3 and 10 m
respectively.
Technical data
Protection class IP41
Power supply internal via communication cable from
EXOcompact or Corrigo E
Connection cable 3 m (E-DSP3) or 10 m (E-DSP10), with
RJ12 fast connector to EXOcompact or
Corrigo E. No other cables are allowed.
Display backlit, LCD, 4 rows of 20 characters
Character height 4.75 mm
Installation
E-DSP can be mounted on a wall or on a wallbox (cc 60 mm). It
can also be mounted on the front of a cabinet using the enclosed
magnet tape. The display cable is connected to Corrigo E or EXO-
compact by an RJ12 modular connector (see figure below).
If the cable is detached from E-DSP, it should be reconnected ac-
cording to the wiring diagram on the back of the unit.
95
E-DSP can also be used as a hand terminal. The included magnet
strips can be fastened to the back, so the display can be attached
to for example a cabinet door. The cable should be lead through
the alternative cable outlet at the lower edge of the connection
area, see the figure below. Prise the cover off and move the cable.
Turn the lid half a turn so the side hole is blocked. Put the cover
back on.
INSTRUCTION
Menu system
The display menu system is accessed using seven buttons:
OK
C
The LEDs have the following functions:
Designation Function
% There are one or more
unacknowledged alarm(s)
There are one or more
remaining, acknowledged
alarm
! You are in a dialogue box
where it is possible to
switch to change mode
Change mode
EMC emission and immunity standards
This product conforms with the requirements of European EMC
standards CENELEC EN 61000-6-1 and EN 61000-6-3 and carries
the CE mark.
�
�
Colour
Flashing red
Fixed red
Flashing
yellow
Fixed yellow