Connecting The Tubeset; Disconnecting The Tubeset; System Operation - Arjohuntleigh Nimbus 4 Mode D'emploi

Connecting the
Tubeset
Disconnecting the
Tubeset
System Operation The system is now ready for use. Refer to
approximately two minutes to ensure that it has
been adequately recharged.
7. If the alarm does not operate for two minutes, call
the service engineer.

If the Power Fail Alarm does not operate after this
test and a service engineer has been called, the
pump can continue to be used with regular checks of
the Power-On status. All other alarms continue to
function as normal.
To connect the tubeset to the mattress and pump:
1. Locate the bottom of the tubeset connector onto the
bottom of the pump/mattress connector.
2. Pull the top of the tubeset connector up and over the
top of the pump/mattress connector, until the
tubeset connector "clicks" into position.
3. Make sure both connections are secure.
To disconnect the tubeset from the mattress and pump:
1. Move the tubeset connector down by pulling the
tubeset extrusion downwards, and then pull the
bottom of the tubeset connector away from the
bottom of the pump/mattress connector.
2. Lift the top of the tubeset connector from the top of
the pump/mattress connector.
Section 4, Page 10 "Controls, Alarms and Indicators"
and Section 5, Page 13 "Operation" for day-to-day
operating instructions.
9
1
2
1
2