Sonia Maia Mode D'emploi page 7

11 Timer
12
Steam volume adjustment button
13
Steam volume indicator
● Configuration and operation
- Plug the power cord into the tower's power socket
and turn on the main switch.
- The water level inside the tank must stand
between the "MIN" and "MAX" levels.
- Press on the control panel and the power
indicator lights up blue. The unit remains in
standby mode and the control panel shows the
following configuration:
• The timer will show 15 minutes.
• The steam volume indicator shows the
maximum level.
• The ozone function indicator is off.
• The heating and steam indicators
• Press the button to switch between the
standby mode and the heating and steaming
functions.
- If the indicator
function is active. The timer will show 30 min
by default and start counting down.
- Once the heating temperature has been
reached, it will be maintained until the timer
reaches 0.
• If the indicator lights up green, the steaming
function is active. The timer will show 15 min by
default and start counting down.
- After a few minutes, steam will start to come
out of the arm head nozzle.
• Set the timer using the
establish the operating time of the different
functions.
- The heating function
90-minute range.
- The steaming function
30-minute range.
- This function allows defining the operating
time for both functions: heating and steaming.
• Use the "ENERGY" button to adjust the steam
volume to be produced by the nozzle
- If the indicator
volume is at maximum level.
- If the indicator
volume is at half level.
- If only one line of the indicator
the steam volume is at the minimum level.
• Activate the Ozone function by pressing the
"OZONE" button. The ozone function indicator
will light up green. Press again to deactivate the
function and the indicator will turn off.
are off.
lights up red, the heating
or buttons to
allows a 1 to
allows a 1 to
lights up in full, the steam
lights up in half, the steam
lights up,
• Adjust the steamer arm at different angles:
- 150º to the left and right
- 60º forward and backward.
- 360º adjustable head
• Add essential oils by opening the sliding lid at
the top of the arm head nozzle and dropping
one or two oil drops onto the cotton.
Bear in mind
• The heating function is a heat conservation
function.
• If, before activating the steaming function,
the heating function has been activated, the
steam is produced faster compared to a direct
steaming function activation.
• If the timer shows "E2" when using the heating
or steaming functions, the "WARNING"
indicator flashes and an acoustic signal sounds,
this indicates that the water level is too high.
The active function will stop immediately.
- Any locked functions will be unlocked as
the water level returns between "MAX" and
"MIN". Press
• If the timer shows "E1" when using the heating
or steaming functions, the "WARNING"
indicator flashes and an acoustic signal sounds,
this indicates that the water level is too low. The
active function will stop immediately.
- Fill with distilled water to unlock functions
and resume operation.
• If you need to change the essential oil, remove
the cotton by opening the sliding lid at the top
of the arm head nozzle, use tweezers to remove
the cotton and replace it with a new one. Add
oil as required.
• Adjust the sound volume of the acoustic signals
of the steamer: with the unit turned off, activate
the main switch located on the side, and then
press and hold the "ENERGY" button until
the Timer reads "5". This is the default sound
volume, which you can adjust using
to resume operation.
or
EN
7