Sonia Maia Mode D'emploi page 5

Brushes
1 2 3
1
Small pumice stone brush
2
Small brush
3 Large pumice stone brush
4
EVA rubber brush
5 Large brush 1
6
Large brush 2
CONNECTION AND ASSEMBLY
INSTRUCTIONS
● Attach the main tower to the base with wheels
using the 4 screws.
● Insert the magnifying lamp into its holder. Plug the
lamp's power cord into one of the accessory power
sockets on the side of the tower.
● Fit the facial steamer in the main tower.
● Unlock the steamer arm (the arm is locked as you
remove the steamer from the box). Following the
arrows in the image, pull out the pin to unlock the
arm and turn it upwards to finish unlocking. The
arm should turn freely, allowing a 150º rotation
angle.
4 5 6
● Unlock the hand-piece holder: Turn the hand-piece
holder upwards until reaching the final position,
as shown in the following images. Then screw the
holder.
● Assembly and disassembly of the high frequency
electrode
1 2
1
Glass part of the electrode
2
Metal part of the electrode
- During assembly and disassembly of the high-
frequency electrode, handle the part with your
hands by the area marked with dashed line,
keeping a distance of 30mm from the metal part
of the electrode
● Place hand-pieces and accessories on the hand-
piece holder as shown in the image.
9
1
2
3
4
1
Roller probe + metal bar
2
Brush handpiece
3
High frequency handpiece
4 Spray tank
5
6
10
7
8
EN
5