Logo Placement; Optional Remote Installation - Napoleon GSS42CFN Instructions D'installation Et D'opération

5.5

LOGO PLACEMENT

Remove the backing of the logo supplied. Centre the
logo on the front of the appliance, ½" (12.7mm) in
from the left side, as shown.

6.0 OPTIONAL REMOTE INSTALLATION

Remove the battery pack from the receiver. Then by pulling down, remove the receiver cover and
A.
slide the receiver into the hole located at the rear of the burner base. Secure using the two screws
provided.
Secure the faceplate to the receiver with two of the screws provided.
B.
Insert the battery pack (with batteries installed) through the opening in the faceplate and into the
C.
receiver. The battery pack is secured and released with a catch mechanism. Push the receiver into
the catch to secure.
Insert the slide switch into its marked position on the faceplate.
D.
Replace the existing switch wires connected to the terminals on the valve marked TH/TP and TH
E.
with those running from the receiver.
NOTE: The remote switch on the side of the appliance is no longer operational.
WARNING : The transmitter and receiver are not waterproof. Ensure both components are not
exposed to water.
½"
(12.7mm)
½"
(12.7mm)
½"
(12.7mm)
½"
(12.7mm)
BATTERY
PACK
SLIDE
SWITCH
RECEIVER
REAR BURNER BASE
FACEPLATE
VALVE
W415-2164 / D / 08.23.18
15
EN