Media Installation; Logo Placement - Napoleon IR3GN Instructions D'installation Et D'utilisation

4.3

MEDIA INSTALLATION

CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
GLASS MEDIA OVER THE BURNER MUST NOT BE MORE THAN ONE LAYER HIGH. MORE THAN ONE LAYER
OVER THE BURNER WILL CAUSE FLAME LIFTING AND SOOTING PROBLEMS.
DO NOT PLACE ANY MEDIA (GLASS OR VERMICULITE) IN OR AROUND THE PILOT OPENING. THIS WILL
Evenly spread the glass media onto the media tray, covering the burner tube and tray.
Glass media over the burner ports may cause a "Puffi ng" sound. To eliminate this sound, simply push the
media away from the burner ports.
NOTE: The distribution of glass media over the burner ports will infl uence the fl ame height. When the
fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
NOTE: Do not use more media than what was supplied with the appliance.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
4.4

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing
door, as indicated.
WARNING
!
THAT IT IS DRY.
DEALER / DISTRIBUTOR.
INTERFERE WITH THE PILOT OPERATION.
13
74.1C
½"
(12.7mm)
LOGO
½"
(12.7mm)
97.1A
W415-1355 / A / 11.16.16
EN