Table des Matières
Publicité
How to use
Kako uporabite
Indicator
Indikator
Tank separation lever
Roïica za loïevanje posode
Pull out
Izvlecite
Tank handle
Roïaj posode
The dust tank needs emptying when indicator light is on.
• Turn off the vacuum cleaner and unplug it.
• Grasp the handle of the tank and then press the tank separation lever.
• Pull out the dust tank.
• Empty the tank and then assemble the dust tank as below
Posodo za prah morate izprazniti, ko zasveti opozorilna luïka.
• Sesalnik izklopite in izkljuïite iz omre¥ja.
• Primite za roïaj posode in pritisnite na roïico za loïitev posode.
• Izvlecite posodo za prah.
• Posodo izpraznite in jo ponovno vstavite, kot je prikazano spodaj.
Assembling dust tank
First, place the bottom of dust tank on the vacuum cleaner and tilt.
Vstavljanje posode za prah
Dno posode za prah postavite na sesalnik in posodo nagnite.
Emptying dust tank
Praznjenje posode za prah
NOTICE
• If suction power decreases after empting dust tank, clean dust tank
• Since dust tank is full, indicator continues to flash for 1 minute and suction power
will decrease for a while, then vacuum cleaner will turn itself off.
OPOMBA
• Ïe po praznjenju posode za prah sesalna moï pade, posodo oïistite.
• Ko je posoda za prah polna, utripa opozorilna luïka 1 minuto, moï sesanja pa se za nekaj
ïasa zmanj•a. Potem se sesalnik samodejno izklopi.
Moving the vacuum cleaner
• Don't grasp the tank handle when you are moving the vacuum cleaner.
The vacuum cleaner's body may fall when separating tank and body.
You should grasp the carrier handle when you are moving the vacuum cleaner.
Premikanje sesalnika
• Ko sesalnik premikate, ga ne vlecite za roïaj posode.
Ïe se posoda loïi od telesa sesalnika, lahko le-ta pade na tla.
Ko sesalnik premikate, ga primite za nosilni roïaj.
Tank handle
Roïaj posode
next page
Naslednja stran
Carrier handle
Nosilni roïaj
25
Publicité
Table des Matières
