Check Sheet For Er2 Series Electric Chain Hoist Frequent Inspection - KITO ER2 Serie Manuel Du Propriétaire

Appendix

Check Sheet for ER2 Series Electric Chain Hoist Frequent Inspection

Electric Chain Hoist
Motorized Trolley
Geared Trolley
Plain Trolley
■ Electric Chain Hoist ER2 Frequent Inspection
■Check result : ○ Good, △ To be replaced (adjusted) next inspection, × Bad, Needs replacement (adjustment)
Category Check item
Daily inspection
Elongation of pitch
Abrasion of wire
diameter
Stretched opening
Abrasion
Deformation, flaw,
corrosion
A
Chain container
Number of start
Switch body size
Push Button Switch cord
Power cable
Cable hanger
Messenger wire
Strange noise
Executed by
Checked by
142
Code Capacity
ER2
MR2
TS2 (TSG)
TS2 (TSP)
Check method
When performing frequent inspection, also perform the
Check the execution
daily inspection.
Sum of pitches for 5 links must not exceed the limit
Pitch measurement
value.
Diameter
Not to exceed the limit value
measurement
Interval between embossed marks not to exceed the
Measurement
limit value
Measurement To have no abrasion exceeding the limit value (5 %)
• To have no bending and twist
Visual inspection
• To have no attached foreign matter such as sputter
• To be mounted securely
• To have no breakage, deformation and foreign matter
Visual inspection
• Lift must be shorter than the length of the permissible
Gap not to exceed the limit value (estimate the time to
Check CH Meter
arrive at one million times)
Visual inspection/ • Operation buttons to move smoothly
inspection by • Emergency Stop button to be enabled to operate and
operation
• To be tied securely
• Protection wire to prevent external force to be applied
Visual inspection
• To have no damage
• To have slack
Visual inspection • To have no damage
• To be connected securely
• To have no damage
Visual inspection • To move with a small force
• To be mounted at equal spacing
Visual inspection • To have no slack
• To have no humming noise from motor and scraping
Lifting/lowering
operation with no
• To have no popping sound of load chain from the
load
Inspector
Maintenance Engineer
Lot No. Your CTRL No. Installation date Location Inspection Certification valid thru
Criteria
capacity of the chain container
cancel
on the cord when being pulled
sound of the brake
chain guide
Inspection date/result
/ / / / / /