Maintenance And Servicing - Dexter power J1G-ZP1A-210D Notice De Montage - Utilisation - Entretien

9. MAINTENANCE AND SERVICING

WARNING! Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
1.When all the adjustments, settings or maintenancehave been done, make sure that all keys
tightened.
2. Keep the tool's air vents unclogged and clean at all times. Occasionally you may see sparks
through the ventilation slots. This is normal and will not damage your power tool.
3. Regularly check to see if any dust or foreign matter has entered the grills near the motor
and around the trigger switch. Use a soft brush to remove any accumulated dust.
4. Wear safety glasses to protect your eyes whilst cleaning.
5. If the body of the saw needs cleaning, wipe it with a soft damp cloth. A mild detergent
can beused but nothing like alcohol, petrol or other cleaning agent.
6. Never use caustic agents to clean plastic parts.
CAUTION: Water must never come into contact with the saw.
7. Store the tool, instruction manual and accessories in a secure place. In this way you will
always have all the information and parts on hand.
8.If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
GENERAL INSPECTION
2. Regularly check the device's power cable and all extension cables used for damage. If
the supply cord needs replacing, the task must be carried out by the manufacturer, the
manufacturer'sagent, or an authorized service centre in order to avoid a safety hazard.
Replace damaged extension cables.
(always replace the two brushes at the same time)
LUBRICATION
The grease in the gearbox will require replacement after extensive use of the tool. Please
refer to an authorised service agent to provide this service.
164
FR
ES
PT
IT
EL
EN