Dexter power J1G-ZP1A-210D Notice De Montage - Utilisation - Entretien page 167

FR
5. Loosen The bevel lock (7) and move the saw arm (1) to the left to the desired bevel angle
ES
(between 0º and 45º). Tighten The bevel lock (7).
6. Place the workpiece flat on the table with one edge securely against the fence (11). If
PT the board is warped, place the convex side against the fence. If the concave side is placed
against the fence, the board could break and jam the blade.
7. When cutting long workpiece, support the opposite end of the workpiece with side
IT
support bars,a roller stand or a work surface that is level with the saw table.
8. Before turning on the saw, perform a dry run of the cutting operation to check that there
are no problems such as a clamp interfering with the cutting action.
EL
9. Hold the operating handle (3) firmly and squeeze the switch trigger (16). Allow the blade
to reach maximum speed and slowly lower the blade into and through the workpiece.
EN
10. Release the switch trigger (16) and allow the saw blade to stop rotating before raising
the blade out of the workpiece. Wait until the blade stops before removing the workpiece.
19. COMPOUND MITRE CUT
If possible, always use a clamping device such as a 'G" clamp to secure your workpiece.
When cutting your workpiece, keep your hands well away from the blade area.
Do not remove a cut-off piece on the right-hand side of the blade using your left hand.
A compound mitre cut involves using a mitre angle and a bevel angle at the same time.
It is used in making picture frames, to cut mouldings, making boxes with sloping sides and
for roof framing. Always make a test cut on a piece of scrap wood before cutting into the
good material.
1. Pull on the Release knob (2) and lift the saw arm to its full height.
2. Loosen the mitre locks (15).
3. Rotate the mitre table (12) until the pointer aligns with the desired angle on the mitre
scale (13).
4. Retighten the mitre locks (15).
5. Loosen The bevel lock (7) and move the saw arm (1) to the left to the desired bevel
angle (between 0º and 45º). Tighten The bevel lock (7).
6. Place the workpiece flat on the table with one edge securely against the fence (11).
If the board is warped, place the convex side against the fence. If the concave side is placed
against the fence, the board could break and jam the blade.
7. When cutting long workpiece, support the opposite end of the workpiece with the side
support bars, a roller stand or a work surface that is level with the saw table.
8. Before turning on the saw, perform a dry run of the cutting operation to check that there
are no problems such as a clamp interfering with the cutting action.
9. Hold the operating handle (3) and firmly and squeeze the switch trigger (16). Allow the
blade to reach maximum speed and slowly lower the blade into and through the workpiece.
10. Release the switch trigger (16) and allow the saw blade to stop rotating before raising
the blade out of the workpiece. Wait until the blade stops before removing the workpiece.
The maximum permissible system impedance is Zmax < 0.45 Ω at the interface point of the
user's supply. The user should determine in consultation with the supply authority, if
necessary, that the equipment is the connected only to a supply of that impedance or less.
163