Dexter power J1G-ZP1A-210D Notice De Montage - Utilisation - Entretien page 165

FR
14. Workpiece clamp
ES
When cutting workpiece,the boards should always be clamped with a hold-down clamp
(provided).
PT
15. CHANGING A BLADE
1. Make sure that the electrical plug is removed from the power point.
IT
2. Match the arrow on the blade with the arrow on the upper blade guard. Make sure that
the blade teeth are pointing downward.
EL
3.Push down on the handle (3) and pull the Release knob (2) to disengage the saw arm
(1).
4. Raise the saw arm (1) to its highest position.
EN
5. Using a Phillips head screwdriver loosen and remove the Phillips head screw that secures
the guard retraction arm (6) to the rotating blade guard (5).
Using a Phillips head screwdriver loosen the Phillips head screw that secures the blade bolt
cover (19).
6. Pull the rotating blade guard (5) down then swing it up together with the blade bolt
19
(4) it is possible to access the blade bolt.
7. Hold the rotating guard (5) up and press the spindle lock button (18). Rotate the blade
until the spindle locks.
8. Use the 6 mm hex key provided to loosen and remove the blade bolt. (Loosen in a
clockwise direction as the blade screw has a left hand thread).
10. Wipe a drop of oil onto the inner blade washer and the outer blade washer where they
contact the blade.
11. Fit the new blade onto the spindle taking care that the inner blade washer sits behind
the blade.
12. Replace the outer blade washer.
14. Use the 6 mm hex key to tighten the blade bolt securely (tighten in an anti-clockwise
direction).
15. Lower the blade guard, hold the rotating lower blade guard (5) and blade bolt cover (19)
16. Replace the guard retraction arm (6) and secure onto the rotating blade guard (5).
17. Check that the blade guard operates correctly and covers the blade as the saw arm is
lowered.
18. Connect the saw to the power supply and run the blade to make certain that it is
operating correctly.
19.The moving guard design only one mode, it can not adjust. Before use, always check the
saw blade guard are fuctioning correctly.
161