Maintenance And Modifications - Klarstein VINOVILLA SMART Mode D'emploi

Modell 10032038
1 In standby mode: press and hold
for 3 seconds, power is turned on,
the machine starts. In the boot state:
short press this button, LED lights on/
off switch. In the boot state: press the
button for 3 seconds, the power is
off, the whole machine is closed.
2 Display the measured temperature
inside the wine cooler.
3 Each time, the temperature inside
will drop 1 °C, until reduced to a
minimum, and then a return to the
highest temperature.

MAINTENANCE AND MODIFICATIONS

Defrosting
Defrost water from the wine cellar storage compartment drains automatically and part
of it goes into a drainage container, which is located at the back of the wine cellar
next to the compressor. The heat is transferred from the compressor and evaporates
any condensation that has collected in the pan. Part of the remaining water is collected
within the wine cellar for humidity purposes. This system enables the creation of the
correct humidity level inside your wine cellar required by the natural cork to maintain a
long lasting seal.
Notes: The water collected by condensation, is therefore recycled. Under extremely
dry environmental conditions, you may have to add some water into the water
container provided with your wine cellar.
EN
31