Care And Maintenance - Klarstein VINOMATICA 36 UNO Mode D'emploi

EN
24

CARE AND MAINTENANCE

Cleaning Your Appliance
• Upon installation of your new appliance, it is recommended that it be cleaned
thoroughly.
• Turn off the wine cooler first and then unplug the unit from the wall outlet.
• Remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking
soda solution.
• The solution should be about 2 tablespoons of baking soda to a quart of water.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
• The outside of the wine cooler should be cleaned with mild detergent and warm
water.
• Dry the interior and exterior with a soft cloth.
• Dust or anything else blocking the vent may hinder the cooling efficiency of the
appliance. Vacuum the vent if necessary.
Vacation Time
• Turn off the wine cooler first and then unplug the unit from the wall outlet.
• Remove all the contents.
• Clean the appliance.
• Leave the lid open slightly to avoid possible formation of condensation, mold, or
odors.
• Short vacations: Leave the wine cooler operating during vacations of less than three
weeks.
• Long vacations: If the wine cooler will not be used for several months, remove
all content and unplug the power cord. Clean and dry the interior thoroughly. To
prevent odor and mold growth, leave the door open slightly: blocking it open if
necessary.
Moving Your Appliance
• Turn off the wine cooler first and then unplug the unit from the wall outlet.
• Remove all the contents.
• Securely tape down all loose items inside your appliance.
• Tape the doors shut.
Energy Saving Tips
• The wine cooler should e located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
• Ensure that door is properly closed when the wine cooler is turned on.