Troubleshooting Guide - Klarstein VINOMATICA 36 UNO Mode D'emploi

TROUBLESHOOTING GUIDE

You can solve many common wine cooler problems easily, saving you the cost of a
possible service call. Try the suggestions below to see if you can solve the problem
before calling for service.
PROBLEM
Wine cooler does not
operate.
Temperature inside
the wine cooler is too
warm.
Temperature inside
the wine cooler is too
cold.
Vibrations.
Moisture forms on
inside wine cooler
walls.
Moisture forms on
outside of appliance.
The door will not close
properly.
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
Temperature control is set too warm. Turn the control to a
cooler setting and allow several hours for the temperature
to stabilize.
Door is kept open too long or is opened too frequently.
Warm air enters the wine cooler every time the door is
opened. Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
The wine cooler has recently been disconnected for a
period of time.
4 hours are required for the wine cooler to cool down
completely.
Temperature control is set too cold. Turn the control to a
warmer setting and allow several hours for the temperature
to stabilize.
Check to assure that the wine cooler is on a level surface.
The wine cooler is touching the wall. Re-level the wine
cooler and move it from the wall.
If continued vibration occurs, turn off the wine cooler and
unplug the power plug. Contact Customer Service Dept. for
further assistance.
Door is slightly open.
Door is kept open too long, or is opened too frequently.
Open the door less often.
The door is not sealed properly.
Door is slightly open, causing cold air from inside the wine
cooler to meet warm moist air from outside.
The wine cooler is not on a level surface. The gasket is dirty.
EN
25