Installation Instructions - Klarstein VINOMATICA 36 UNO Mode D'emploi

EN

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for
approximately 4 hours. This will reduce the possibility of a malfunction in the cooling
system from improper handling during transportation. Clean the interior surface with
lukewarm water using a soft cloth. (Cleaning instruction on page 9)
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and should not be recessed or
built-in.
Allow 5 cm of space between the back and sides of the wine cooler, which allows
the proper air ventilation. Adjust the feet to keep the wine cooler level. Locate the
wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Ambient temperature below 5°C or above 32°C will hinder the
performance of this appliance.
Depending on the location of the appliance, the direction of the door opens can be
changed.
This unit is not designed for use in a garage or any other outside installation.
Avoid locating the wine cooler in moist areas.
Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized service center.
After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit
to cool down for 3 ~ 4 hours under before placing wine bottles or beverages in the
appliance.
Note: Keep ventilation openings in the appliance enclosure, clear of obstruction.
20