Operation - Klarstein VINOMATICA 36 UNO Mode D'emploi

OPERATION

Description of the product features
1. Control panel
The control panel is located at the top of the appliance, it is very easy to set
thetemperature of the appliance and see what temperature the appliance is set to.
2. Interior light
The wine cooler has an interior light. The light can be switched on and off by using
the light control button.
3. The wine cooler shelve
The shelves are fully adjustable to suit various wine bottle shapes and sizes.
To prevent damaging the door gasket, make sure the door is fully open when
pulling shelves out of the rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 1/3. The
shelves are designed with an emergency stop to prevent them being removed too
far when loaded.
Before switching on
• Make sure that it has been installed by a suitably qualified person, as per the
information contained in the installation instructions.
• After delivery, wait for four hours before connecting the appliance to your mains
supply. This will allow any refrigerant gasses that may have been disturbed during
the transportation process to settle.
• The outside of the appliance and the removable accessories contained within it,
should be cleaned with a solution of liquid detergent and water.
• The interior of the appliance should be cleaned with a solution of sodium
bicarbonate dissolved in lukewarm water.
• The interior and accessories should be thoroughly dried, after the cleaning process
has been completed.
• There can be an odour when you first switch on the appliance. It will lessen as the
appliance starts to cool.
EN
21