First Use; Daily Use - Electrolux EUT1105AOW Notice D'utilisation

6 www.electrolux.com
3.2 Switching on
Leave the appliance to stand upright for 4
hours after installation.
Insert the plug into the wall socket.
1. Turn the Temperature Regulator
clockwise to the Full Loaded position.
The Green Indicator Light will light up and
remain lit until the appliance is switched
off.
2. Leave to run for 8 hours to allow the
correct temperature to be reached
before placing food inside.
The Red Indicator Light will stay on
until the correct temperature is
reached.
3. When the appliance has reached the
set temperature (the Red Indicator
Light has gone out) adjust the
Temperature Regulator according to
the quantity of the stored foods.
A few hours after starting up
the Red Indicator Light will go
out to show that the correct
temperature has been
reached for the setting
chosen and will stay out to
indicate that everything is in
order. It will come on if the
freezer temperature rises
unduly for instance, after
opening the freezer door or
placing food inside the
cabinet, but the light should
go out again when the
temperature returns to the
correct storage level.

4. FIRST USE

4.1 Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap to
remove the typical smell of a brand-new
product, then dried thoroughly.

5. DAILY USE

WARNING!
Refer to Safety chapters.
3.3 Switching off
1. To turn off the appliance, turn the
Temperature Regulator to the "O"
position.
2. To disconnect the appliance from the
power, disconnect the mains plug
from the wall socket.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• turn the Temperature Regulator toward
lower settings to obtain the minimum
coldness.
• turn the Temperature Regulator toward
higher settings to obtain the maximum
coldness.
In case of freezing less food
volumes, the Half Loaded
setting is the most suitable. In
case of freezing large food
volumes, the Full Loaded
setting is the most suitable.
CAUTION!
Do not use detergents or
abrasive powders, as these
will damage the finish.