Gaggia Milano ANIMA PRESTIGE Mode D'emploi page 32

English
32
Problem
The brew group cannot
be inserted.
Coff ee does not have
enough crema or it is
watery.
Coff ee drops leak from
the dispensing spout.
Coff ee is not hot enough. The cups that have been used are
The machine grinds cof-
fee beans, but the coff ee
is not dispensed.
Coff ee is dispensed
slowly.
Frothed milk is cold.
Cause
The brew group is not in its correct
position.
The machine is still performing the
descaling cycle.
The coff ee grinder is set to a coarse
grinding.
The coff ee blend is not suitable.
The machine is performing the
autoregulation operation.
The brew group is dirty or it needs
lubrication.
The coff ee dispensing spout is
clogged.
The coff ee outlet duct is clogged.
cold.
The set temperature is too low. Check
the menu settings.
You have added milk.
The coff ee outlet duct is clogged.
The coff ee grinder is set to a too fi ne
grinding.
The brew group is dirty.
The coff ee dispensing spout is dirty.
The coff ee grinder is set to a too fi ne
grinding.
The brew group is dirty.
The coff ee outlet duct is clogged.
The machine circuit is clogged by
limescale.
The cups are cold.
Solution
The brew group has not been placed in its right
position before being put back. Ensure that the
lever is in contact with the base of the brew
group and the hook of the brew group is in its
right position (see: "Reinserting the Brew Group").
To reset the machine: put the drip tray and the
coff ee grounds drawer back. Do not inset the
brew group. Close the maintenance door, switch
off the machine and switch it on again. Try to
reinsert the brew group.
When the descaling procedure is enabled, the
brew group cannot be removed. Wait for the des-
caling cycle to end, then remove the brew group.
Adjust the coff ee grinder to a fi ner grinding.
Change the coff ee blend.
Prepare some cups of coff ee.
Clean the brew group.
Clean the coff ee dispensing spout and its holes
with a bottlebrush.
Clean the coff ee outlet duct.
Pre-heat the cups washing them under hot water.
Set the menu temperature to "MAX".
Adding hot or cold milk always lowers the coff ee
temperature to some extent.
Clean the coff ee outlet duct using the handle of
the measuring scoop or the handle of a spoon.
Switch off the appliance and switch it on again.
Set the coff ee grinder to a coarser grinding.
Clean the brew group.
Clean the coff ee dispensing spout and its holes
with a bottlebrush.
Use a diff erent coff ee blend or adjust the coff ee
grinder.
Clean the brew group.
Clean the coff ee outlet duct using the handle of
the measuring scoop or the handle of a spoon.
Perform the descaling.
Preheat the cups using hot water.