Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Receiver for a Wireless Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Operating Elements
and Connections
1 Receiving antennas
2 IR transmitting diode
3 Button ADL, to transfer the radio frequency of
the receiver to the transmitter by IR signal; set-
tings for the transmitter (transmission power and
gain) made on the receiver will also be transferred
4 Display (
☞
fig . 3 and chapter 1 .1)
5 Buttons SET, AUTO,
Automatic lock function:
A short while after switching on and after the
last operation, the buttons SET, AUTO,
will be locked automatically (lock symbol
on the display) . To unlock the buttons or to lock
them again, keep the button SET pressed for
approx . 1 second .
1. Setting mode: When the buttons are un-
locked, use the button SET to call up the fol-
lowing functions one after another:
Group setting channel setting squelch setting
setting of transmission power for the transmitter
gain setting for the transmitter exit of setting mode
1.1 Display
Indication
and
Function
strength of the radio signal
received
volume of the audio signal
received
radio frequency
group
channel
indicates the battery status
of the transmitter in several
levels
As long as the indication of the function se-
lected keeps flashing, settings can be made
with the buttons
2. Volume: When the buttons are unlocked, use
the buttons
output signal of the receiver (range 0 ... 63) .
3. Automatic channel scan: When the buttons
are unlocked, press the button AUTO to start
the channel scan within a group .
6 Button POWER to switch the receiver on / off
(keep button pressed for approx . 1 second)
and
7 Power supply jack to connect the power supply
unit provided
8 Audio outputs, one each for connection to a
microphone input or to a highly sensitive line
input (e . g . of a mixer or amplifier)
– XLR chassis plug, balanced
– 6 .3 mm jack, unbalanced
9 Antenna inputs A and B (BNC jacks)
Indication
Function
an antenna symbol will indicate the receiver
section (A or B) receiving the radio signal of
the highest quality
wave symbol will pulsate during IR trans-
mission
starts flashing during the channel scan
squelch, adjustable in 3 levels
buttons SET, AUTO,
setting for the transmitter:
transmission power, adjustable in 3 levels
setting for the transmitter: matching of
volume level (0 dB, –3 dB, –6 dB)
and
.
and
to set the volume for the
,
locked
9
Publicité
Table des Matières
