Conformity And Approval; Operation; Configuring The System Via The Menu - Monacor International JTS RU-8011DB/5 Mode D'emploi

3.2 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the product RU-8011DB / 5 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
IT
The regulations of the country where the prod-
uct is operated must always be observed Prior
to operating the product, please contact the
MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the follow-
ing Internet address:
www cept org
tECC
tTopics
tOther spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
tEFIS and National Frequency Tables

4 Operation

1) Insert the antennas (1) provided into the
antenna jacks (9) and put them in a vertical
position
Hint: To increase the range and the interference
resistance, use antenna amplifiers from JTS (e g
UB-900I) The amplifiers are supplied with power
via the antenna jacks of the receiver
2) Connect the receiver to the subsequent audio
unit, e g mixer or amplifier Depending on the
input available at the subsequent unit, use one
of the following two outputs:
– XLR output (11):
balanced output for connection to a micro-
phone input (in this case, activate the 20 dB
☞
attenuation: chapter 5 1 4) or to an input
for units with line signal level
– 6 3 mm output jack (10):
unbalanced output for connection to an
input for units with line signal level
EL FI FR
LT MT PL
3) For power supply, connect the power supply
unit provided to the power supply jack (13)
and to a mains socket (230 V/ 50 Hz) The re-
ceiver is provided with a strain relief (12): Lead
the cable around the hook at the bottom of
the housing to prevent accidental disconnec-
tion of the power supply unit from the receiver
Note: The power supply unit will still consume some
power when the receiver has been switched off
Therefore, always disconnect the power supply unit
from the mains socket if the receiver is not operated
for a longer period of time
4) Use the rocker switch (8) to switch on the
receiver ( I = "on", O = "off")

5 Configuring the System via the Menu

The configuration menu consists of two sections:
RX (settings for the receiver) and TX (settings for
the transmitter) The menu structure can be found
on page 2
1) To call up the menu, keep the button SET (7)
pressed for approx 2 seconds
briefly appear on the display; then the selec-
tion mode for the menu section will be acti-
vated: The menu section RX is selected (
starts flashing) To go to the menu section TX,
press the button

return to the section RX, press the button
2) When the menu section has been selected,
press the button SET repeatedly until the menu
item desired has been reached
3) To change a setting, use the button
4) To save a change, press the button SET The
display will show
be exited
Note: Setting the radio frequency requires two steps;
therefore, the setting will be saved after the second
step (after the channel has been selected or the last
three digits of the frequency have been set)
To exit the menu without any changes, press the
button SET repeatedly until
on the display The menu will be exited automati-
cally after 10 seconds when no button is pressed
Further information with regard to the settings can
be found in the following chapters 5 1 and 5 2
( starts flashing) To
or
 
Then the menu will
is briefly shown
will

(6)
13