SERVODAN Enocean Minilux 41-580 Guide De Montage Et D'utilisation page 6

The RF signal is affected by other high frequency signals:
Devices that also operate with high-frequency
signals, such as computers, audio/video appliances,
mobile telephones, electronic transformers,
connection units, frequency converters and other
RF transmitting/receiving equipment are considered
to be a source of noise for a wireless RF signal. We
therefore recommend a minimum distance to such
devices of 0.5 metres.
RF transmitter rate of recurrence:
The Solar PIR sensor only sends an RF signal if there
is suffi cient light energy to the solar cell and the room
is in use. The PIR sensor will then transmit an RF
signal as a function of an event-controlled process,
but also in a fi xed time-controlled process.
Measurement principle and telegram delivery:
a) Delivery of an event-controlled process can take
place by activating the button labelled "LRN", which
causes the internal microprocessor to start, the status
of the PIR sensor to be registered and an RF signal to
be transmitted immediately to the receiver. However,
this is only the case if the sensor is receiving
suffi cient light energy via the solar cell.
b) Delivery of a time-controlled process. At a
suitable interval of 10 seconds (T_wake up), the
microprocessor is started and the status of the PIR
sensor is registered. If there is no change, for every
100 events (event control) an RF telegram will be
transmitted to the receiver approximately every 1000
seconds. This status is defi ned when the PIR sensor
is continually activated and there is suffi cient light
energy via the solar cell.
Default set up of STM110:
T_wake up: 10, T_event: 10
T_send = 10 wake up x 10 event = 100 sec.
EnOcean Profi le:
Profi le 0b000111 – Occupancy Sensor
Type 0b0000001 – Occupancy Sensor 1
Manufacturer ID 0b00000000011
DATA BYTES
DB_1:
PIR off 0 to 127
PIR on 128 to 255
DB_0.BIT_3:
Learn button 0 = Teach-in telegram
1 = Data telegram
Technical data
Input:
Power supply: .............................. Solar cell,
zero-energy.
Light conditions for function ....... more than 80 lx
measured
by Lux meter.
guideline – 25 W
incandescent light
bulb distance
approx. 50 cm
Power consumption .................... <10µW
Protection .................................... IP20
Temperature range ...................... +5°C to +50°C
indoor use
Performance:
Installation height ........................ 2.5 to 4 metres
Range .......................................... 360°, ø7-12 m
Signal type/range:
RF signal EnOcean technology ... 868 MHz, <10 mW
RF range ...................................... 100 metres in open
space/line of vision
30 metres in
buildings, see RF
wireless information
Approval:
CE according to ..... R&TTE 1999/5/EC
ETSI EN 301 489-1: 2005-09
ETSI EN 301 489-3: 2002-08 (SRD class 2)
ETSI EN 300 220-3: 2000-09
6(12)