Electrical Connection; Operating Temperature; Ventilation; Start Up - Siemens pureFlow DW03500 Serie Notice D'utilisation

Attach the red hose of the hose set to the con-
■
nection valve (6c) (see figure d).
d
Open the main tap of the house water supply.
■
Open the connection valve (6c) again and check
■
the connection for leaks.
Water pressure:
A minimum of 0.14 MPa (1.4 bar)
A maximum of 0.83 MPa (8.3 bar)
If the pressure is under 0.14 MPa (1.4 bar), a
■
pressure booster pump is to be built in.
If the pressure is over 0.83 MPa (8.3 bar), a pres-
■
sure reducer is to be built in.
Water temperature
Cold water line temperature: 5 – 35 °C
Info
If the water supply is very dirty, it is recommended
that a pre-filter* be installed. This part is available
under order number BZ00PF1.
* not WQA (Water Quality Association) certified
32
All manuals and user guides at all-guides.com
en

Electrical connection

■
The socket must be located in the vicinity of the
Water Purifier and be freely accessible.
■

Operating temperature

Permissible room temperature: + 10 to 43 °C

Ventilation

Never cover the ventilation and breather openings.
Otherwise, the cooling system must work harder
and more electrical power will be consumed.

Start up

Important

The appliance must be connected to the water sup-
ply line and to the waste water line.
The appliance must remain inoperative for at least
30 minutes before connecting to the electric circuit
and starting up (to avoid damage to the cooling
system).
■
Activating the filters
■
■
Only plug the appliance plug into a separate
electrical socket.
Modifications to the connection must be made
by a specialist.
Before using the appliance, please fill and com-
pletely empty out the filtered water two-times
from the water tanks.
To do this, proceed as follows:
Insert the plug into a separate electrical socket.
Switch the On/Off switch (14) to
ly light up, then just the selected LEDs remain lit.
LED Hot water
I. All LEDs brief-
LED Cold water