Installation; Safety Information - Siemens pureFlow DW03500 Serie Notice D'utilisation

Declaration of conformity
The filter system is tested in accordance with
Standard NSF/ANSI 58 for reduction of pentavalent
arsenic, barium, cadmium, mercury, selenium, ra-
dium 226/228, trivalent and hexavalent chromium
and lead as well as nitrates/nitrites. The results
have been confirmed by laboratory tests. The water
purifier is tested in accordance with Standard NSF/
ANSI 42, 53 for reduction of chlorine and volatile

Installation

Safety information

Risk of electric shock!
– The statutory regulations of the respective coun-
try, as well as those of the local electricity and
water suppliers must be adhered to.
– Only install the appliance in accordance with the
local rules and regulations.
– First connect to the water connection and drain,
then connect the electrical power supply.
– The Water Purifier must be disconnected from
the mains power network during installation.
– Make sure that the house's electrical earth/
grounding system is installed in accordance with
the regulations.
– Do not use extension cables.
– Only plug into a separate electrical socket. Do
not share electrical outlet with other devices.
– The Water Purifier has only to be installed in a
frost-free room.
– Protect plastic parts and cables from high
temperatures.
– Only connect to a cold tap water line.
– Only connect to a water supply that meets
the regulatory requirements of the respective
country.
– Only erect in hygienically clean areas.
28
All manuals and user guides at all-guides.com
en
organic compounds, including laboratory testing
which has confirmed the results. This appliance is
approved for the treatment of supply water concen-
trations of up to a maximum of 27 mg/l nitrates and
3 mg/l nitrites (combined) and is approved for water
pressure of 0.14 MPa – 0.83 MPa.
–
–
–
–
–
–
–
–
–
Do not subject the appliance to shaking, vibra-
tions or jolts.
Do not erect in the vicinity of a heating source,
or place in direct sunlight, or install in rooms
that are very moist.
Erect the appliance away from flammable gases
or combustible materials.
Make sure that there is sufficient air circula-
tion. Do not erect in closed cabinets, closets or
lockers.
A minimum distance of 10 cm must be main-
tained between the appliance and any wall/ob-
ject. Maintain free space around the filter cover
to allow for filter changes.
Only set the Water Purifier on a level, flat surface
that is designed to support such a weight.
The electrical plug must be freely accessible after
erection of the appliance.
Unpack the appliance and check for transport-
related damage.
Please dispose of the packaging, and if appli-
cable, the old appliance in an environmentally-
friendly manner.