Signal Routing On The Audio Outputs; Regulating The Audio Output Volumes - Viscount Chorale 3 Mode D'emploi

Owner's Manual Viscount Chorale 3

6.4 SIGNAL ROUTING ON THE AUDIO OUTPUTS

Another useful setting available on the Chorale 3 is the option of sending the signals of the individual
manuals and pedal board to one audio output or both. This allows you to simulate location of the windchests
in different positions by allocating the external speakers as required.
To display the setting video page, select the EXT. OUT ROUTER field in the SET UP menu:
The screen shows the two audio outputs, OUT1 ([OUTPUT 1]) and OUT2 ([OUTPUT 2]). You can set
the signal source section for each output, as follows:
o PEDAL: pedal board only.
o MAN.I: first manual only.
o MAN.II: second manual only.
o PEDAL + MAN.I: pedal board and first manual.
o PEDAL + MAN.II: pedal board and second manual.
o MAN.I + MAN.II: first and second manual.
o GENERAL: whole organ.
o REVERB ONLY: reverb effect signal only.
As usual, use the [FIELD ] and [FIELD ] buttons to move the cursor and [VALUE +] and
[VALUE -] to adjust the values.
To conclude, press [EXIT] to save the new settings and return to the SET UP menu.

6.5 REGULATING THE AUDIO OUTPUT VOLUMES

Another setting function available for the audio outputs is adjustment of the volumes of the individual
outputs. To make the settings, select the EXT. OUT VOLUME field in the SETUP menu; the display
shows the screen:
63